Table of Contents
Advertisement
Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.10.4
Terminal Block and Power Cord – Removal and
Replacement
At the terminal box (junction box), replace the terminal block in
the event the terminal threads are stripped, or if there is any other
damage to the component. The power cord is also replaced at the
terminal box.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 182: Terminal Block Positioned In the Terminal Box
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Detach all wire leads from each terminal on the terminal block and
from the grounding screw (see Figure 182). Retain all nuts,
washers / lockwashers and grounding screw, and make a note of
all the wire connections.
3. If replacing the power cord, after detaching the wires from the
terminal block, pull the cord out from the terminal box.
4. Remove and retain the two screws that secure the terminal block
onto the terminal box.
5. Replace the terminal block if needed.
58300000163852_ARA_EN_C
6.10.5
Electrical Wiring Connections at the Terminal Block
For electrical wiring requirements and safety precautions, refer to the
Installation Manual for this appliance.
NOTE: The electrical wiring diagram is located on the back side of the
kick panel (see Wiring Diagram, page 6).
6.10.6
Cooling Fan Removal and Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
Sharp Component – Use Gloves
Use gloves when handling the cooling fan, as it has sharp edges
Figure 183: Typical Cooling Fan (View from Under the Mounting
Bracket)
1
Screw locations (2) securing bracket onto the range.
Page 103 of 123
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
