Warming Drawer Display Module - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
5. Inside the control panel, remove and retain the small and large
screw for the left endcap (see Figure 94, page 60); the power LED
bracket then will be detached.
NOTE: You do not have to remove the door handle assembly.
3. Detach the wire connector for the power LED indicator, and
remove the LED and its two wire leads from the bracket (see
Figure 94, page 60).
4. Replace the power LED indicator if needed.
6.8.2.1 Warming Drawer Display Module – Removal and
Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
1. Follow all safety precautions and steps in the Preparing the Range
for Servicing, page 25.
2. Remove the warming drawer control panel (see Warming Drawer
Control Panel, page 59).
3. Detach the wire connectors on the warming drawer display
module.
4. Remove and retain the four nuts from the respective standoffs
(see Figure 94, page 60), then gently pull the warming drawer
display module off of the standoffs.
5. Replace the warming drawer display module if necessary (see
Figure 95 and Figure 96).
6. When replacing the warming drawer display module, you must
also replace the gasket if it is damaged or missing (see
Figure 97).
NOTE: A replacement gasket comes with adhesive on one side.
58300000163852_ARA_EN_C
Figure 95: Display Module (Shown Removed, Front Side)
Figure 96: Display Module (Shown Removed, Back Side)
Figure 97: Display Module and Gasket
Page 61 of 123