Water Tank Housing And Funnel Assembly Components - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.7.13 Water Tank Housing and Funnel Assembly Components
– Removal and Replacement
Access is from the back and the front of the range. The water
tank housing and funnel assembly are attached when removed.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing these components.
1. Follow all safety precautions and steps in the Preparing the Range
for Servicing, page 25.
2. Remove the backguard (see Backguard Removal and
Replacement, page 100).
3. Remove the back steam oven panel (see Back Panel for Steam
Oven – Removal and Replacement, page 102).
4. Remove both the warming drawer and warming drawer cavity
from the back of the range (see Removing the Warming Drawer
and Cavity from the Range, page 64).
5. Remove the water tank (see Figure 77).
Figure 77: Removing the Water Tank
1 Bezel
58300000163852_ARA_EN_C
NOTE: Do not remove the bezel or pry it open in order to remove
tank housing / funnel assembly (see Figure 78).
Figure 78: Do Not Remove the Bezel
6. From the back of the range, locate the two studs that secure the
water tank housing / funnel assembly onto the range chassis
(see Figure 79, page 54).
7. Use a 2-foot long rachet extension fitted with a 5/16 inch
deep-well socket (Figure 80, page 54) and flashlight to remove
and retain the three nuts with lockwashers from the respective
screws on the housing / funnel assembly – two at the top of the
housing / funnel assembly, and one at the base (see Figure 79,
page 54).
8. From the back of the range, pull to detach the water tube from the
evaporator cup (see Figure 81, page 54).
9. From the back of the range, detach the wire connector from the
valve on the funnel assembly (see Figure 81, page 54).
Page 53 of 123