Oven Lamp Assembly And Bulb - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.11.4 Oven Lamp Assembly and Bulb – Removal and
Replacement
The oven lamp is located inside the large oven cavity. To replace
the oven lamp assembly, access is from both the front and top of the
range. However to replace just the bulb, access is only from the front
of the range.
NOTE: Before servicing the oven lamp, see Oven Light Diagnostics,
page 22.
NOTE: For servicing the lamp in the steam oven, see Oven Lamp for
Steam Oven – Removal and Replacement, page 38.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing these components.
A replacement bulb can be obtained through
QuickFinder. Alternatively, you can use any
commercially available bulb with the following
specification:
10 W, 12 V, G4 base (bi-pin) Halogen lamp
58300000163852_ARA_EN_C
Figure 193: Oven Lamp Assembly
1 Fixing clip
2 Groove at side of fixing clip
3 Lens (lamp cover)
4 Groove at side of holder clip
5 Halogen bulb
6 Holder clip
7 Wire connector
8 Lamp holder
9 Lamp housing
Page 108 of 123