Aligning The Door; Large Oven Convection Components - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.11.5.3

Aligning the Door

On models that have an alignment mechanism as a part of the hinge
receiver, you can adjust the door alignment by rotating the alignment
screw that is located below each hinge / hinge receiver slot.
1. Make sure the door is installed correctly so it will not pose any
danger by falling while adjusting the screw (see Installing the
Door, page 111).
2. Locate the alignment screw below the door hinge (Figure 199).
3. Use a T-27 driver to turn the alignment screw until the door is
properly aligned.
Figure 199: Alignment Screw (Shown with Door Removed)
1 Slot for hinge
2 Hinge receiver screw
NOTE: Do not rotate the hinge receiver screw. It
is not used for door alignment.
3 Door alignment screw
58300000163852_ARA_EN_C
6.11.6 Large Oven Convection Components – Removal and
Replacement
Convection components are accessed from the front of the
range.
Be sure to check QuickFinder for relevant information, documentation,
and correct part numbers when replacing any of these components.
Figure 200: Convection Components – Large Oven
1 Motor for convection fan
2 Bracket
3 Insulation
4 Rear cover shield
5 Reflector cover shield
6 Shim ring
7 Fan
8 Nut
9 Convection element
10 Front cover
Page 112 of 123