Control Panel Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02

6.6 Control Panel Removal and Replacement

Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Complete steps for Accessing Components under the Maintop,
page 25.
3. Remove only the rangetop burner knobs from the control panel.
4. At the bezels on the control panel, remove and retain the screws
that connect to the two manifold support brackets. These are
located at the second-from-left and second-from-right bezels (see
Figure 37).
Figure 37: Locations of Manifold Support Brackets
1 Location attached to manifold support bracket
2 Location attached to manifold support bracket
5. Remove both the right and left side panels (see Side Panel
Removal and Replacement, page 32).
6. Remove and retain the screws from underneath the control panel
(see Figure 38).
58300000163852_ARA_EN_C
Figure 38: Removing Screws under the Control Panel
7. Remove the screws securing the control panel flange onto the top
of the front crossmember (located behind the control panel). See
Figure 39.
Figure 39: Removing Control Panel Screw Attaching Control Panel
Flange onto Front Crossmember
Page 35 of 123