Control Boards For The Large Oven - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
4. Carefully pull out the bracket (see Figure 150).
Figure 150: Removing the Temperature Gauge Bracket
5. At the front of the range, pull the temperature gauge outward to
remove it, and then detach the wire connector (see Figure 151).
Figure 151: Detaching the Wire Connector (Shown with
Temperature Gauge Removed)
6. Replace the temperature gauge if necessary.
58300000163852_ARA_EN_C
6.9.12 Control Boards for the Large Oven – Removal and
Replacement
This procedure is for replacement of the large oven control
board. For replacement of the steam oven control board, see Steam
Oven Control Board– Removal and Replacement, page 39.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
3. Remove the griddle in order to gain access to the main control
board (see Griddle / Grill Removal and Replacement, page 30).
Figure 152: Cover Shield
1 Screws (2) on cover shield
Page 87 of 123