Standard Valve Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
Figure 130: Removing Jet Holder Assembly
Figure 131: Alignment Boss (Shown from Below Burner Support
Rail)
1 Alignment boss
58300000163852_ARA_EN_C
6.9.2

Standard Valve Removal and Replacement

The standard valves do not have XLO or XHI functionality.
Standard valves are accessible from under the maintop, and can be
replaced without removing the control panel.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 132: Standard Valve
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
3. Remove the control panel (see Control Panel Removal and
Replacement, page 35).
4. Use a 9/16 inch wrench to remove the hex nuts on the gas tube
that is connected to the standard valve and to the jet holder
assembly, and then remove the tube.
5. From under the manifold, use a 1/4 inch wrench to remove and
retain the valve screw that secures the standard valve onto the
manifold. Be careful not to lose the rubber washer attached to the
screw (see Figure 139, page 81).
6. Remove the standard valve from the manifold. Be careful not to
lose the red rubber washer attached to the standard valve.
Page 77 of 123