Lighting Bar For Control Panel - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
Figure 156: Removing the LED Indicator
6.9.15 Lighting Bar for Control Panel – Removal and
Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
3. Remove the control panel (see Control Panel Removal and
Replacement, page 35).
4. Remove the LED indicator retaining brackets (see LED Indicator
Removal and Replacement, page 89).
5. Detach the lighting bar wire connector (see Figure 157).
6. Use a flat-blade screwdriver to detach the lighting bar from the
tape that holds it onto the control panel. Tape is at the left, center,
and right locations on the lighting bar (see Figure 158).
58300000163852_ARA_EN_C
NOTE: When installing a replacement lighting bar, be sure to affix
the tape at the same three locations.
Figure 157: Detaching the Lighting Bar Wire Connector
Figure 158: Removing the Tape from the Lighting Bar
1 Location of tape securing lighting bar to control panel
2 Location of tape securing lighting bar to control panel
3 Location of tape securing lighting bar to control panel
Page 90 of 123