Large Oven Door Components - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
m
Caution
Abrasive Materials
Do not use abrasive cleaners or materials, such as steel wool, as they
may scratch the glass
4. Insert a clean, non-abrasive wash cloth or rag into the bottom vent
to clean. You may need a flexible brush to reach the entire surface
(see Figure 220, page 119).
6.11.10 Large Oven Door Components – Removal and
Replacement
Be sure to check QuickFinder for relevant information,
documentation, and correct part numbers when replacing any of these
components.
NOTE: For the removal and replacement of steam oven door
components, see Steam Oven Door – Removal and Replacement of
Glass with Drip-Tray Assembly, page 58).
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Remove door (see Oven Door Removal, Installation, and
Alignment, page 110).
3. Place the door on a protective mat with the handle facing down.
4. Remove and retain the four screws from the base of the door
assembly (two from each side), as shown in Figure 221.
NOTE: Do not remove the other four screws from the base of the
door assembly.
58300000163852_ARA_EN_C
5. At the base of the door assembly, gently lift the inner glass panel
upward slightly while removing the two lower retaining brackets
that are positioned around the door hinges (see Figure 221).
6. Gently pull the inner glass panel out in the direction of the door
base, at a slight angle. Be careful that the upper bracket doesn't
damage the glass panel during removal (see Figure 221).
Figure 221: Large Door Components
1 Screw to remove (1 on each side of door)
2 Screw to remove (o1 on each side of door)
3 Upper bracket (1)
4 Inner glass panel
5 Lower retaining brackets (1 on each side of door)
Page 120 of 123