Steam Oven Door Hinge Receiver - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.7.17 Steam Oven Door Hinge Receiver – Removal and
Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing these
components.
1. Follow all safety precautions and steps in the Preparing the Range
for Servicing, page 25.
2. Remove the warming drawer control panel (see Warming Drawer
Control Panel, page 59).
3. Remove both the warming drawer and warming drawer cavity
from the back of the range (see Removing the Warming Drawer
and Cavity from the Range, page 64).
4. Remove steam oven door (see Oven Door Removal, Installation,
and Alignment, page 110).
5. Remove and retain the two hinge receiver screws (Figure 87), and
pull out the hinge receiver from inside the warming drawer cavity.
58300000163852_ARA_EN_C
Figure 87: Removing the Screws
1 Screws (2) holding hinge receiver
Page 57 of 123