Installing The Door - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
5. When the door is lifted sufficiently to clear the hinge hooks, pull
the door straight out (see Figure 198), and place it in a safe
location.
Figure 197: Prying Locking Lever Downward with Screwdriver
Figure 198: Hinge Shown Removed
58300000163852_ARA_EN_C
6.11.5.2

Installing the Door

1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. While firmly grasping the door on both sides, position the door
open at an angle of approximately 15–25 degrees, and insert both
hinges into their respective slots. The hinges will be securely
hooked into the slots when properly installed. It may be necessary
to press firmly inward on the lower portion of the door, using a
rocking motion to fully seat the door's hinges.
NOTE: Do not let the door fall. Do not force or bend the door.
3. Open the door fully, and then use a flat blade screwdriver to push
the locking levers upward all the way (away from you) into the
hinge slots.
NOTE: Be careful not to scratch the range during this process.
4. Open and close the door slowly to make sure the door is
positioned properly and closes with a tight fit.
NOTE: Do not force the door to open or close. If the door is
properly installed, it should move smoothly and be positioned
straight on the front of the range when closed.
5. If the door does not operate correctly, verify that the hinges are
properly seated into the hinge slots, and that the locking levers are
fully engaged into the slots. If the door is not aligned correctly, see
Aligning the Door, page 112.
Page 111 of 123