Removing The Bulb; Removing The Oven Lamp Assembly - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.11.4.1

Removing the Bulb

1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Remove the oven racks.
3. While supporting the lens with one hand, insert a flat-blade
screwdriver into the groove for the holder clip, and press down
gently while rotating the screwdriver. This releases the clip, so that
you can pull out the lens out from that side (without removing the
holder clip from the housing). See Figure 193 and Figure 194.
4. On the other side of the lens, gently pull it out from underneath the
fixing clip, without removing the fixing clip from the housing.
Figure 194: Releasing the Lens from the Holder Clip
5. Remove the bulb by carefully pulling it straight out to ensure its
two prongs do not break off inside the lamp holder (socket).
6. When installing a Halogen bulb, to prevent premature burn-out of
the bulb, never handle it with bare hands. Handle the bulb with
clean, dry gloves, or a clean, dry tissue or cloth.
58300000163852_ARA_EN_C
6.11.4.2

Removing the Oven Lamp Assembly

1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
3. [If range has a griddle]: Remove the griddle / grill assembly (see
Griddle / Grill Removal and Replacement, page 30).
4. Locate the oven lamp wire connector for the lamp assembly you
want to replace, then detach the wire connector (see Figure 195).
NOTE: For ranges with a griddle, the wire connectors are located
under the griddle.
Figure 195: Wire Connectors for an Oven Lamp Assembly
Page 109 of 123