Service And Repair; Preparing The Range For Servicing; Component Removal Videos; Accessing Components Under The Maintop - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6

SERVICE AND REPAIR

6.1 Preparing the Range for Servicing

For most servicing of this appliance (for example, involving
disassembly, or component removal / installation), you will need to do
the following prior to starting:
■ Turn off the gas supply to the range (close gas valve at the wall)
■ Turn off the electrical power to the range by removing the power
cord from the electrical outlet, and putting the circuit breaker in the
OFF position
■ Make sure the range components are not hot before servicing
■ Wear protective clothes: long sleeves, gloves, safety glasses
If testing the appliance requires the use of electrical power and/or an
open gas supply, exercise extreme caution.

6.2 Component Removal Videos

See QuickFinder for videos of component removal.
The video symbol indicates the availability of a video to
view in QuickFinder for the corresponding procedure.
58300000163852_ARA_EN_C

6.3 Accessing Components under the Maintop

This section contains the steps required to gain access to the
components located under the maintop(s).
6.3.1 Removing Knobs, Grates, Burner Assemblies, Maintops,
Heat Shields, Burner Support Rails
To access and service components located underneath the
maintops, first remove the knobs [optional], grates, and burner
assemblies. Then remove maintops, heat shields, and burner support
rails [optional].
1. [Only if a component needs replacing that requires control
panel removal]: Remove all knobs from valve stems by slowly
pulling knobs straight out, away from control panel.
2. Remove all grates.
3. Remove rangetop burner caps (see Figure 15).
Figure 15: Rangetop Burner with Cap
Page 25 of 123