Element Gasket And Frame - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
Figure 114: Affixing Wire Harness to Back Panel with Tape
1 Wire harness taped to back panel
7. Remove and retain the two screws inside the sensor housing, and
then pull the sensor wires through the receptacle to remove it from
the housing (see Figure 115).
8. Replace the sensor if needed.
Figure 115: Sensor Screws (Left), Removing the Sensor (Right)
1 Screws (2) to remove
58300000163852_ARA_EN_C
6.8.8 Element Gasket and Frame – Removal and Replacement
You can service the element gasket and frame with or without
removing the warming drawer from the cavity.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing any of these components
1. Perform steps 1–6 of the Removing the Warming Drawer from the
Cavity procedure, page 66.
2. Perform steps 2–3 of the Warming Drawer Sensor – Removal and
Replacement procedure, page 68.
3. Remove and retain the seven screws (three from the front plate
and two from each side of the warming drawer housing), and then
remove the front plate (see Figure 116).
Figure 116: Front Plate and Screw Locations
1 Screws (4) – two on each side of housing
2 Screws (3) on front plate
Page 69 of 123