Oven Temperature Gauge Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
5. At the back side of the control panel, detach the multi-pin wire
connector from the switch, and then remove it.
6. Replace the selector switch if necessary (see Figure 147).
Figure 147: Selector Switch and Bezel
1 Selector switch
2 Screw locations (2) inside the bezel cutout that hold
the switch in place
6.9.11

Oven Temperature Gauge Removal and Replacement

The temperature gauge is for the large oven only. Assess is from
the top and front of the range.
The gauge shows the temperature setting the user has selected, not
the current oven temperature.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
58300000163852_ARA_EN_C
Figure 148: Oven Temperature Gauge (Front, and Back Views)
3. At the back of the control panel, remove and retain the two nuts
with lockwashers from their respective studs on the bracket (see
Figure 149).
Figure 149: Removing a Nut with Lockwasher on the Temperature
Gauge Bracket
1 Nuts with lockwashers (2)
Page 86 of 123