Removing The Warming Drawer Front Panel - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.8.3

Removing the Warming Drawer Front Panel

If you have already disassembled the warming drawer control
panel and need to service or access other areas of the warming
drawer, this procedure may be necessary. If you have already
removed the warming drawer control panel without disassembling it
(per the Removing the Warming Drawer Control Panel Assembly
procedure, page 63), then this procedure doesn't apply.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in the Preparing the Range
for Servicing, page 25.
2. Remove the warming drawer control panel (see Warming Drawer
Control Panel Components – Removal and Replacement,
page 59).
3. Remove and retain the four screw-and-washer sets from the inner
side of the front panel, and then remove the front panel (see
Figure 98).
4. Push the warming drawer assembly back in.
58300000163852_ARA_EN_C
Figure 98: Removing Screws with Nuts & Washers
1 Screw and washer (4 sets)
2 Front panel
Page 62 of 123