Griddle / Grill Thermostat Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
Figure 166: Removing the Plunger Switch Bezel
6.9.19

Griddle / Grill Thermostat Removal and Replacement

To replace the griddle/grill thermostat, access is from the top of
the range.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 167: Typical Thermostat
m
Caution
When installing the thermostat, extend the capillary tube to the
needed length, however be careful not to twist or bend it, or it may
impede the component's ability to operate properly.
58300000163852_ARA_EN_C
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
3. Remove and retain the two screws on the bezel of the thermostat
knob. These screws connect the thermostat to the back side of the
control panel.
4. Remove thermostat bulb from the retaining bracket in the griddle
tray, and then gently pull it through the receptacle (see Griddle /
Grill Removal and Replacement on page 30, and Figure 168).
5. Remove the thermostat from the back of the control panel, and
replace it if needed.
Figure 168: Removing the Thermostat Bulb from Retaining Bracket
1 Retaining bracket
2 Thermostat bulb
Page 95 of 123