Flap Components For Steam Oven - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
4. If obstructing access to the actuator access panel, remove the
burner support rail (with jet holder assemblies attached) by
following the steps in Removing the Burner Support Rail, page 28.
5. Remove the control board shield, and then detach the wire
connector from the control board as shown in Figure 51, page 41.
6. Remove and retain the two screws on the actuator, and then
remove the actuator (see Figure 52).
7. Replace the actuator if needed.
Figure 52: Actuator
1 Screws (2) on actuator
58300000163852_ARA_EN_C
6.7.7 Flap Components for Steam Oven – Removal and
Replacement
Flap components are accessed from the front and/or top of the
range.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing these components.
Figure 53: Flap Assembly
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
3. Remove and retain screw from the access cover, and then
remove the cover.
4. Gently remove the flap lid by pulling it out from the clip (see
Figure 54, page 43).
5. From inside the steam oven cavity, use a wrench to secure the
arm, while you gently remove the clip (see Figure 55, page 43).
Page 42 of 123