Simmer Control Board Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
4. Remove and retain the two screws attaching the cover shield to
the range chassis (see Figure 152, page 87).
5. Remove all multi-pin wire connectors from the control board as
well as the spade connector of the ground wire (see Figure 153).
NOTE: It is always recommended to label and tag all wires, wire
connectors, and harnesses prior to disconnecting them so as to
correctly identify their connections/locations when reassembling.
Alternatively, you can photograph prior to disconnecting (for
example, with your mobile phone).
Figure 153: Control Board (Board for Large Oven Shown)
1 Standoff
2 Multi-pin wire connectors
58300000163852_ARA_EN_C
m
Caution
Fragile Components
Be careful not to exert too much pressure on the standoffs or the
control board, as these are fragile components.
6. Use a needle nose pliers to disengage the control board from all
the plastic standoffs by lightly pressing the tiny protruding clip on
each standoff, while simultaneously pulling the control board off
the standoff.
7. Replace the control board only if needed.
6.9.13

Simmer Control Board Removal and Replacement

There are two simmer boards; one for the two XLO burners on
the right, and another for the two XLO burners on the left.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
3. Remove and retain the screw to detach the ground wire from the
chassis (see Figure 154, page 89).
4. Detach the two multi-pin side connectors from the simmer board
(see Figure 154, page 89).
m
Caution
Fragile Components
Be careful not to exert too much pressure on the standoffs or the
simmer control board, as these are fragile components.
Page 88 of 123