Microswitch And Glass Heating Element - Removal And Replacement70 - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
4. Remove the frame and then remove the element gasket (see
Figure 117 and Figure 118).
Figure 117: Removing Frame (left) and Gasket (right) – Shown with
Warming Drawer Removed
Figure 118: Removing Frame & Gasket (Warming Drawer Installed)
5. Replace the gasket or frame if needed
58300000163852_ARA_EN_C
6.8.9 Microswitch and Glass Heating Element – Removal and
Replacement
You must remove the warming drawer from the cavity when
servicing the microswitch or heating element.
1. First, follow the entire procedure for Removing the Warming
Drawer from the Cavity, page 66.
2. Perform steps 2–3 of the Warming Drawer Sensor – Removal and
Replacement procedure, page 68.
3. Remove the frame and then remove the element gasket (see
Element Gasket and Frame – Removal and Replacement,
page 69).
-OR-
Defer removing the gasket and frame until step 9a in this
procedure (this may make performing step 5 easier).
4. Remove the two screws from each side of the glass heating
element housing that hold the wiring tray (see Figure 119).
5. While securing the glass element assembly with one hand,
position the warming drawer housing standing on its side, and
then detach the wire tray (see Figure 119).
Figure 119: Removing Wire Tray Screws from Housing
Page 70 of 123