Back Panel For Steam Oven - Removal And Replacement; Back Panel For Large Oven - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.10.2 Back Panel for Steam Oven – Removal and Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
Figure 180: Back Panel for Steam Oven
1 Screw locations for small back panel (11)
2 Screw locations for small back panel (8) located on
the warming drawer support bracket
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Remove the backguard, per Backguard Removal and
Replacement procedure, page 100.
3. Remove and retain the eleven screws from the back panel, as well
as the eight screws from the warming drawer support bracket, and
then remove the back panel (see Figure 180).
4. Replace the back panel if needed.
58300000163852_ARA_EN_C
6.10.3 Back Panel for Large Oven – Removal and Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
Figure 181: Back Panel for Large Oven
1 Back panel for large oven
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Remove the backguard, per Backguard Removal and
Replacement procedure, page 100.
3. Detach the power cord wires from the terminal block, and remove
the power cord.
4. Remove and retain the eight screws from the back panel, and
then remove the back panel.
5. Replace the back panel if needed.
Page 102 of 123