Removal And Replacement Of Back-Accessible Components - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
16. Replace the LCD board if needed.
NOTE: All four dipswitch settings on the LCD board should be in
the OFF position (see Figure 175).
17. If the button guide was not already removed per step 8 of this
procedure, you can detach the button guide by using a small
screwdriver to press lightly on the four black standoff at the back
of the button board (see Figure 171, page 97).
Figure 175: LCD Board (Front Side, Showing LCD)
1 Dipswitches (4)
18. Remove the button guide from the other side of the button board
(see Figure 176), and replace the button board or button guide if
needed.
58300000163852_ARA_EN_C
Figure 176: Button Guide and Button Board
6.10 Removal and Replacement of Back-Accessible
Components
This section contains removal and replacement procedures for the
components that can be accessed from the back of the range.
NOTE: Before and after servicing the range from the back, refer to the
Installation Manual for instructions on moving the range, leg
adjustment, installing the anti-tip bracket and other important
installation and safety information.
Moving the Range
For servicing that requires access from the back of the range, it may
be necessary to move the range. Due to the immense weight of the
range, using an air dolly to move it may reduce the risk of injury
and/or damage. It is also recommended to have more than one
person to move the appliance.
Page 99 of 123