Warming Drawer Door Handle Assembly - Removal And Replacement; Warming Drawer Power Led Indicator - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.8.1.1 Warming Drawer Door Handle Assembly – Removal
and Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
1. Follow all safety precautions and steps in the Preparing the Range
for Servicing, page 25.
2. Remove the warming drawer control panel (see Warming Drawer
Control Panel, page 59).
3. Inside the control panel, remove and retain the small and large
screw for each of the two endcaps (see Figure 94), and then
remove the door handle assembly. The endcaps slide off (see
Figure 93).
NOTE: The power LED bracket becomes detached as well when
the left endcap screws are removed.
4. Replace the door handle tube or endcaps as needed.
Figure 93: Door Handle Assembly (Shown Removed)
58300000163852_ARA_EN_C
6.8.2 Warming Drawer Power LED Indicator – Removal and
Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
1. Follow all safety precautions and steps in the Preparing the Range
for Servicing, page 25.
2. Remove the warming drawer control panel (see Warming Drawer
Control Panel, page 59).
Figure 94: Components inside the Control Panel
1 Small screw for right endcap
2 Large screw for right endcap
3 Display module
4 Nuts (4) on standoffs (4)
5 Large screw for left endcap (also holds LED indicator
bracket)
6 Small screw for left endcap
7 Bracket for power LED indicator
8 Power LED indicator
Page 60 of 123