Ignition (Spark) Module Removal And Replacement; Door Latch Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.9.16

Ignition (Spark) Module Removal and Replacement

Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
Figure 159: Ignition (Spark) Module
1 Screws (2)
2 Wire connectors (2)
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
58300000163852_ARA_EN_C
3. If obstructing access to the ignition module, remove the burner
support rail (with jet holder assemblies attached) by following the
steps in Removing the Burner Support Rail, page 28.
4. Pull to detach the two side connectors from the ignition module
(see Figure 159).
5. Remove and retain the two screws securing the ignition module to
the range chassis (see Figure 159).
Replace the ignition module if needed.
6.
6.9.17

Door Latch Removal and Replacement

Removing and replacing the door latch requires access from both
the top and front of the range.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
3. Remove the corresponding oven door (see Oven Door Removal,
Installation, and Alignment, page 110).
4. If obstructing access to the door latch access panel, remove the
burner support rail (with jet holder assemblies attached) by
following the steps in Removing the Burner Support Rail, page 28.
Page 91 of 123