Removal And Replacement Of Steam Oven Components - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
Figure 42: Protective Matting and Control Panel on Top of Range
1 Control panel
2 Folded protective matting over the top of range
10. You can leave the remaining wire connectors attached (for
components not requiring replacement) if you are to leave the
control panel at the range.
-OR-
Alternatively, you can label and then detach the wire connectors of
the control panel components if the control panel will not be kept
at the range.
58300000163852_ARA_EN_C
6.7 Removal and Replacement of Steam Oven
Components
Steam oven components can require access from the front, back, top,
and/or left side of the range.
For steam oven troubleshooting tips, see Steam Oven Diagnostics,
page 22.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing any of these components.
Use care when opening the oven door during or immediately after
operation. Stand to the side of the oven when opening an oven door
to allow hot air or steam to escape. Keep face well away from the
open door to avoid injury.
Figure 43: Components inside Steam Oven Cavity
1 Lamp
2 Convection cover and convection fan (not shown)
3 Rack support standoffs (4)
4 Rack supports (2)
Page 37 of 123