Rack Support Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
8. From the side of the range, detach the wire connector, and then
remove the receptacle (see Figure 190 and Figure 191).
9. Replace receptacle or other meat probe components as needed.
Figure 190: Detaching the Meat Probe Wire Connector
Figure 191: Removing the Meat Probe Receptacle
58300000163852_ARA_EN_C
6.11.3

Rack Support Removal and Replacement

Figure 192: Rack Support Shown with Screw and Washer
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Remove oven trays.
3. Remove the oven door (see Removing the Door, page 110).
4. At the right and left sides of the oven cavity, remove and retain the
two screws and washers from the rack support (see Figure 192).
5. Remove the rack support from the oven, and replace if needed.
Page 107 of 123