Steam Oven Convection Components - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.7.11 Steam Oven Convection Components – Removal and
Replacement
For the steam oven, the convection motor and element require
access from both the back and front of the range. The convection fan
and front cover are accessed only from the front of the range.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in the Preparing the Range
for Servicing, page 25.
2. Remove the backguard (see Backguard Removal and
Replacement, page 100).
3. Remove the back steam oven panel (see Back Panel for Steam
Oven – Removal and Replacement, page 102).
4. [To remove the cover]: From inside the steam oven cavity,
remove and retain the four convection cover screws, and then
remove the cover.
5. [To remove the fan]: Use an adjustable wrench to rotate the nut
clockwise. Remove and retain the nut (see Figure 72).
6. Use gloves to remove the fan and the shim ring that is positioned
behind the fan (see Figure 72), and replace the fan if needed.
58300000163852_ARA_EN_C
Figure 72: Convection Element and Fan (Cover Removed)
1 Element standoffs (2) – removed from back of range
2 Element
3 Nut
4 Fan
Page 50 of 123