Rack Supports For Steam Oven - Removal And Replacement; Oven Lamp For Steam Oven - Removal And Replacement; Gasket For Steam Oven Door - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.7.1 Rack Supports for Steam Oven – Removal and
Replacement
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Remove all trays and gliding racks from the steam oven cavity.
3. Rotate rack support standoffs and remove them (see Figure 43,
page 37).
4. Remove the rack supports (see Figure 43, page 37).
6.7.2 Oven Lamp for Steam Oven – Removal and Replacement
Check QuickFinder for relevant information, documentation, and
the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Remove the rack support from inside the steam oven cavity (see
Rack Supports for Steam Oven – Removal and Replacement,
page 38).
3. Rotate the lamp cover (lens) counter-clockwise to remove. Do not
lose the rubber O ring.
4. Pull out the bulb.
5. Wear clean gloves while replacing the Halogen bulb.
NOTE: To service the lamp housing and wire connectors, access
is from the right side panel (see Side Panel Removal and
Replacement, page 32).
58300000163852_ARA_EN_C
6.7.3 Gasket for Steam Oven Door – Removal and
Replacement
Be sure to check QuickFinder for relevant information,
documentation, and correct part numbers when replacing any of these
components.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Start the mounting of the gasket from the middle of the vertical
side next to the water tank. While carefully working your way
counter-clockwise to the other end, avoid wrinkles and "waves" in
the gasket by ensuring it is correctly in place within the groove:
stretch it at the corners, while pressing it in a straight line at the
horizontal areas. Make sure the entire perimeter is covered
without any wrinkles, waves, or loss of shape to the gasket. See
Figure 45, page 39.
3. After replacing the gasket, check to make sure the door is
positioned correctly, and closes with a tight fit
NOTE: For troubleshooting tips, see Steam Oven Diagnostics,
page 18.
Figure 44: Steam Oven Gasket
Page 38 of 123