Wiring Diagram; Recommended Tools And Supplies - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02

1.3 Wiring Diagram

The wiring diagram is located on the back side of the kick panel
(see Figure 2).
Figure 2: Wiring Diagram Location
1 Kick panel (wiring diagram located on back side)
58300000163852_ARA_EN_C

1.4 Recommended Tools and Supplies

The following are recommended to use when servicing this appliance:
m
Caution
Power Drivers
If using a power driver, set the clutch to the lowest setting
ü Flat blade screwdrivers: large, small
ü Precision flat-blade screwdriver with a high-strength blade,
1/8 inch (3.0 mm) wide, .020 inch (0.50 mm) thickness tip
ü Drivers: T-10, T-20, T-27, T-30
ü 2 foot long rachet extension
ü Rachet with 6-inch long (min.) swivel head extension
ü 6 inch long (min.) flex extension
ü 5/16 inch deep-well socket
ü 1/4 inch nut driver
ü Adjustable wrenches (2)
ü Strap wrench
ü Open-end wrench sizes: 1/4 inch, 9 mm, 11 mm, 1/2 inch,
9/16 inch, 5/8 inch, 3/4 inch, 5/16 inch
ü Pipe wrench
ü Needle-nose pliers
ü Clean putty knife
ü Protective gloves
ü Gas leak test equipment
ü Pipe sealant
ü Small mirror
ü Air lifter / air dolly
ü Floor protection
ü Protective eye wear (such as glasses, goggles)
ü Flashlight
ü Amp meter
ü Thermometer with thermocouple leads
ü Multimeter
ü Clean, non-abrasive cleaning cloth & flexible brush
Page 6 of 123