Removing The Warming Drawer And Cavity From The Range - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.8.5 Removing the Warming Drawer and Cavity from the
Range
This procedure is only necessary if you are servicing the
following steam oven components: reed sensor board, water tank
assembly, evaporator cup (heater) assembly, and steam oven door
hinges. Otherwise, you should remove the warming drawer
separately, without also removing the cavity (see Removing the
Warming Drawer from the Cavity, page 66).
1. Follow all safety precautions and steps in the Preparing the Range
for Servicing, page 25.
2. Detach the control panel from the warming drawer (see Removing
the Warming Drawer Control Panel Assembly, page 63).
3. Remove the large oven door (see Removing the Door, page 110).
4. Remove the kick panel (see Kick Panel Removal and
Replacement, page 121).
5. Remove the backguard (see Backguard Removal and
Replacement, page 100).
6. Remove and retain the two screws on the front panel, as well as
the two screws on the inside (left and right) cavity walls. See
Figure 102.
58300000163852_ARA_EN_C
Figure 102: Removing Screws on Front Panel of Warming Drawer
1 Screws (2) on front panel
2 Screws (2) on inside (left and right) cavity walls
Page 64 of 123