Power Module For Steam Oven - Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
Figure 48: Control Board for Steam Oven
1 Multi-pin wire connectors
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
3. Remove all multi-pin wire and sliding connectors from the control
board.
NOTE: It is always recommended to label and tag all wires, wire
connectors, and harnesses prior to disconnecting them so as to
correctly identify their connections/locations when reassembling.
Alternatively, you can photograph prior to disconnecting (for
example, with your mobile phone).
58300000163852_ARA_EN_C
m
Caution
Fragile Components
Be careful not to exert too much pressure on the standoffs or the
control board, as these are fragile components.
4. Use a needle nose pliers to disengage the control board from all
the plastic standoffs by lightly pressing the tiny protruding clip on
each standoff, while simultaneously pulling the control board off
the standoff. Use caution at the side with the heat sink.
5. Replace the control board only if needed.
6.7.5 Power Module for Steam Oven – Removal and
Replacement
Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
3. Detach the wire connector from the board (see Figure 49,
page 41).
4. First make a note how the three spade connectors are attached to
each terminal on the board, and then detach the spade
connecters (see Figure 49, page 41).
NOTE: It is always recommended to label and tag all wires, wire
connectors, and harnesses prior to disconnecting them so as to
correctly identify their connections/locations when reassembling.
Alternatively, you can photograph prior to disconnecting (for
example, with your mobile phone).
Page 40 of 123