Removing The Warming Drawer Control Panel Assembly - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
6.8.4

Removing the Warming Drawer Control Panel Assembly

This procedure may be needed when accessing or servicing
other areas of the warming drawer.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in the Preparing the Range
for Servicing, page 25.
2. Pull to open the warming drawer, and from the back of the control
panel remove and retain the four screw-washer sets (see
Figure 99).
3. Pull the control panel out slightly, and then from underneath the
warming drawer detach the multi-pin wire connector (see
Figure 100 and Figure 101).
Figure 99: Removing Screws and Washers at Back of Control Panel
Assembly
58300000163852_ARA_EN_C
Figure 100: Multi-Pin Wire Connector on Control Panel Assembly
1 Multi-pin wire connector (female) on control panel
Figure 101: Detaching the Multi-Pin Wire Connector
Page 63 of 123