Led Indicator Removal And Replacement - Thermador Pro Grand Next Generation PRD48JDSGC/02 Service Manual

Service Manual for the Thermador Pro Grand Next Generation, Dual Fuel Range with Steam Oven, Models: PRD48JDSGC/02, PRD48JDSGU/02
5. Use a needle nose pliers to disengage the control board from the
four plastic standoffs by lightly pressing the tiny protruding clip on
each standoff, while simultaneously pulling the simmer board off
the standoff (see Figure 154).
6. Remove and replace the simmer control board if needed.
NOTE: Please explore other possible causes before replacing
the simmer control board. Approximately 75% of all simmer
control boards returned to the factory turn out to be ok.
Figure 154: Simmer Control Board
1 Multi-pin wire connectors (2)
2 Standoffs (4)
3 Ground wire (shown attached to screw on chassis)
6.9.14

LED Indicator Removal and Replacement

Be sure to check QuickFinder for relevant information,
documentation, and the correct part number when replacing this
component.
58300000163852_ARA_EN_C
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 25.
2. Follow all steps in Accessing Components under the Maintop,
page 25.
3. Remove the control panel (see Control Panel Removal and
Replacement, page 35).
4. Remove and retain the two screws to detach a LED Indicator
retaining bracket from the control panel (see Figure 155).
Figure 155: LED Indicator Retaining Bracket
1 Wire connector
2 Screws on bracket (2)
5. While holding the two sides of a wire connector, rotate them to
detach (see Figure 155).
6. Push the protruding clip at the front end of the LED indicator while
you simultaneously push the LED indicator frontward through the
hole in the control panel (see Figure 156, page 90).
7. Replace the LED indicator if needed.
Page 89 of 123