Step 8: Door Removal And Installation - Thermador PRO-GRAND PRG30 Installation Manual

Range Width
30"
36"
48"
Step 8: Door Removal and
Installation
CAUTION:
USE CAUTION WHEN REMOVING THE
DOOR. THE DOOR IS VERY HEAVY.
• Make sure oven is cool and power to oven
has been turned off. Failure to do so could
result in electrical shock or burns.
• The oven door is heavy and fragile. Use
both hands to remove or replace the door.
• Grasp only the ends of the oven door
handle.
• Failure to grasp the oven door firmly and
properly could result in personal injury and
product damage.
• With the door off, never release the levers
and try to close the hinges. Without the
weight of the door, the powerful springs will
snap the hinges closed with great force.
To Remove the Oven Door:
• Open the door fully and use a screwdriver to pry the
hinge clips away from the hinge slots. (See Photo A.)
• Flip the hinge clip toward you (See Photo B.)
• Close the door until it stops against the hinge clips. The
open hinge clips will hold the door open at a slight
angle.
• Grasp the door on the ends of the door handle, and lift
the door up. (There will be some spring resistance to
overcome.) When the door is lifted sufficient to clear
the hinge hooks, the door can be pulled straight out.
(See Photo C.)
• Place the door in a safe and stable location.
To Reinstall the Oven Door:
• Position the door at a slight angle and insert the hinges
into the hinge slots - one on each side of the range.
Chart C: Backguard Kit Model Numbers
9" Std. Low Back
Included
N/A
N/A
22" Pot and Pan
12" Low Back
N/A
LB36R
LB48R
The hinges will securely hook into the slots when
properly installed. Do not force, bend, or twist the door.
Tip:
Rest the door on your foot while using your leg for stability.
• Open the door fully and use a screwdriver to push the
hinge clips all the way into the hinge slots. Be careful
not to scratch the range during this process.
To Check Door Fit and Operation:
• Open and close the door slowly to test the movement
and the fit of the door to the oven cavity. Do not force
the door to open or close. If the door is properly
installed, it should move smoothly and rest straight on
the front of the range when closed.
• If the door does not operate correctly, verify that the
hinges are properly seated into the hinge slots, and
that the hinge clips are fully engaged into the slots.
Photo A: Pry hinge clips out using a screwdriver.
3-3/4" Island Trim
Shelf
HS30R IT30R
HS36R IT36R
HS48R IT48R
English 15