Aligning The Door - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
rest straight on the front of the range when closed. If the door does
not operate correctly, verify that the hinges are properly seated into
the hinge slots, and that the locking levers are fully engaged into the
slots. If the door is not aligned correctly, see Aligning the Door.
4.7.3.3

Aligning the Door

On models that have an alignment mechanism as a part of the hinge
receiver, you can adjust the door alignment by using the alignment
screw that is located below each hinge / hinge receiver slot.
1. Make sure the door is installed correctly so it will not pose any
danger by falling while adjusting the screw (see Installing the
Door, page 88).
2. Locate the alignment screw below the door hinge (see
Figure 170 and Figure 171).
3. Use a T-27 driver to turn the alignment screw until the door is
properly aligned.
Figure 170: Alignment Screw (View at Small Door of 48-Inch Range)
1 Alignment screw
58300000156573_ARA_EN_B
Figure 171: Alignment Screw (Shown with Door Removed for Clarity)
1 Slot for hinge
2 Hinge receiver screw (do not rotate this screw as it
is not for door alignment)
3 Door alignment screw
Page 89 of 119