Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 825

 Input signal type
The input signal type can be selected by using Central remote controller interface.
To select the input signal type, do as follows:
1. Tap Menu button.
2. Tap "Installer Setting".
3. Tap "External Input Setting".
4. Tap "Operation" and select following operation for external input.
5. Tap "Input method" and select following input method.
Edge
6. When "OK" button is tapped, setting is complete.
4-3. Central remote controller (UTY-DCGYZ1)
• Emergency Stop: Enables Emergency stop by external input
• All On/Off: Enables batch operation on or off by external input
• Not Used: Does not receive external input signals
• Edge button: Detects the signal rise and fall
• Pulse button: Detects the signal level
- (08-71) -
The width of pulse must be
longer than 300 msec.
Pulse
4. Controller