Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 819

 Input signal type
The input signal type can be selected by using Central remote controller interface.
To select the input signal type, do as follows:
1. Press the
• Emergency Stop button: Enables Emergency stop by external input
• All On/Off button: Enables batch operation on or off by external input
• Not Used button: Does not receive external input signals
2. Press the
• Edge button: Detects the signal rise and fall
• Pulse button: Detects the signal level
Edge
3. When the
 Control input function
• In case of Edge input:
Connector
CN6 or CN11
4-2. Central remote controller (UTY-DCGY)
button and move the cursor to the "Operation" menu.
button and move the cursor to the "Input Method" menu.
button is pressed, setting is complete.
CN6 or CN11
All on / Emergency stop
Indoor unit
All off / Normal
Pulse
Input signal
Off → On
On → Off
On
Off
- (08-65) -
The width of pulse must be
longer than 300 msec.
Command
All on / Emergency stop
All off / Normal
4. Controller