Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 699

Function
Function
number
Control
switching of
62
external
heaters
Auto mode
68
type
Deadband
69
value
Standby
time for
auxiliary 71
equipment
operation
Heat pump
backup 72
setting
Emergency
73
heat
Fan delay
74
time
2-9. Function details
Factory
Setting number
setting
00 Setting 0
01 Setting 1
02 Setting 2
03 Setting 3
04 Setting 4
05 Setting 5
06 Setting 6
07 Setting 7
08 Setting 8
09 Setting 9
10 Setting 10
11 Setting 11
12 Setting 12
13 Setting 13
14 Setting 14
15 Setting 15
16 Setting 16
17 Setting 17
Single setpoint
00 auto mode
(traditional)
Dual setpoint auto
01
mode
00 0 °F (0 °C)
01 0.9 °F (0.5 °C)
02 1.8 °F (1.0 °C)
03 2.7 °F (1.5 °C)
04 3.6 °F (2.0 °C)
05 4.5 °F (2.5 °C)
06 5.4 °F (3.0 °C)
07 6.3 °F (3.5 °C)
08 7.2 °F (4.0 °C)
09 8.1 °F (4.5 °C)
00 Disabled
01 1 minute
02 2 minutes
• •
• •
• •
98 98 minutes
99 99 minutes
00 Disabled
01 Enabled
00 Disabled
01 Enabled
00 1 minute
01 50 seconds
02 40 seconds
03 30 seconds
♦
Sets the temperature conditions when the external
heater is on.
For the temperature conditions, refer to
conditions when the external heater is on/off"
page 07-100.
Switches the setting method of auto mode to single or
♦ dual (cooling/heating).
For heat pump systems, it is necessary to set the
master indoor unit by using wired remote controller.
NOTE: Auto mode type will be usable provided
that the corresponding operating device is
connected.
♦
Choose the minimum temperature between cooling
and heating settings (deadband) for dual setpoint
auto mode (function number 68).
NOTE: Deadband value will be usable provided
that the corresponding operating device is
connected.
♦
Sets the standby time until the auxiliary equipment
operation starts during primary equipment operation.
For details, refer to
EXTERNAL INPUT AND OUTPUT on page 08-5.
♦ Enables or disables the heat pump backup instruction
from the outdoor unit. This function will be usable
provided that the corresponding outdoor unit is
connected.
♦
Enables or disables the emergency heat input.
♦
Sets the fan delay time when the heater is turned off.
- (07-99) -
Details
"Temperature
"External output" in Chapter 8.
2. Function settings
on