Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 730

NOTE: For canceling the existing master unit setting and applying the master unit setting to
other indoor unit, always perform the resetting of current setting first. Then perform
the master unit setting to the other indoor unit.
• Wired remote controller
a. After the indoor unit stops operation, press the MODE button of wired remote controller
for 5 seconds continuously.
After 5 seconds, the operating mode indicator on the wired remote controller display
lights on.
When the unit is not set as the adminis-
trative indoor unit (A):
b. Press the MODE button.
– The indicator blinks when the MODE button is pressed, and the indication of 1-(A)
and 1-(B) alters whenever the MODE button is pressed.
– The setting configured on the wired remote controller is transmitted to the indoor unit
immediately after the selection of (A) or (B) is completed. It may take 10 seconds or
so depending on the communication conditions. During this period, the button opera-
tion will be suspended.
– It automatically returns to the regular display after 20 seconds if there is no button
entry.
– When the setting or canceling is completed, the indication on the wired remote con-
troller changes to the regular indication from blinking.
NOTES:
When operation lock indicator
following reasons:
• "Priority on administrative indoor unit" is not selected in the setting of priority mode of the
outdoor unit.
In this case, select "Priority on administrative indoor unit" in setting of priority mode of
the outdoor unit first. Then set the administrative indoor unit on the wired remote con-
troller.
• Another indoor unit has already been set as the administrative indoor unit.
In this case, cancel the administrative indoor unit setting of another indoor unit.
c. Complete the setting or canceling of the administrative indoor unit.
Press the MODE button of the wired remote controller again for 5 seconds continuous-
ly. The indication returns to the regular display.
(It returns to regular indication after 20 seconds even if the MODE button is not
pressed.)
2-24. Administrative indoor unit setting
lights on, the MODE button is locked because of the
Operation-lock indicator
- (07-130) -
When the unit is set as the administrative
indoor unit (B):
2. Function settings