Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 622

5. Send the information by pressing the START/STOP button once. A beeping sound (2 short
beeps, 1 long beep, 2 short beeps, and 1 long beep) will be emitted if the command is accept-
ed.
In the following cases, the setting signal will not be accepted correctly and 5 short beeps will be
emitted:
• The indoor unit address number is set out of range (64 or more)
• The setting of the rotary switch on the indoor unit PCB is not set to "00"
6. Indoor unit lamps will indicate the refrigerant circuit address data number as follows:
OPERATION
(Green)
1 sec ON
1 sec OFF
• When the address setting is "0", TIMER lamp and FILTER lamp will not flash.
• Address indication will be switched automatically from indoor unit address to refrigerant cir-
cuit address.
 Confirmation of address setting
To confirm the address setting is properly configured, press the TIMER set (+) button.
TIMER set (+) button
1-4. Address setting by remote controller
TIMER FILTER
(Orange) (Red)
Flashes times of Flashes times of
address numbers address numbers
(the left digit) (the right digit)
Beeps are emitted
intermittently
(2 short beeps,
1 long beep, 2 short beeps,
and 1 long beep)
Example) ADDRESS: 25
OPERATION lamp
(Green)
0.5sec ON / 0.5sec OFF
TIMER lamp
(Orange)
2 times
0.5sec ON / 0.5sec OFF
FILTER lamp
(Red)
Beeps are emitted intermittently as follows:
Correct:
Wrong:
(3 sec)
- (07-22) -
1sec ON / 1sec OFF
1 - 10 sec
1 - 10 sec
5 times
(2 short beeps,
1 long beep, 4 short beeps,
and 1 long beep)
(2 short beeps and 1 long beep)
1. System settings