Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 617

 Entering function setting mode
NOTE: Be sure that all the procedures described in
• The position of the MANUAL AUTO button varies depending on the model. For the actual position
of the button on each unit, refer to the operation manual.
• If the MANUAL AUTO button is pressed continuously for 10 seconds or more, the error will be dis-
played. In this case, release the button or turn off the power.
1. Press and hold the MANUAL AUTO button for 3 seconds.
2. While holding down the FAN and the SET TEMP.
function setting mode will be activated.
 Selection and confirmation of custom code
1. In function setting mode display, press the SET TEMP.
code that matches the setting with the indoor unit. By selecting the appropriate custom code,
the communication between the indoor unit and the wireless remote controller become possi-
ble.
1-4. Address setting by remote controller
"Preparation"
MANUAL AUTO
IR receiver unit
FAN
SET TEMP. ( )
RESET
Custom code
( - - - )
The initial setting is " "
- (07-17) -
on page 07-15 are completed.
3 short beeps
MANUAL
AUTO
buttons, press the RESET button. The
Function setting
mode display
or button to select the custom
1. System settings