Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 397

¢ Installation space
• This product cannot be installed in wall.
• Recommendation installation height of the remote controller is 1.4 m55 in (1.4 m) from the floor
surface to the bottom of the remote controller.
• Even when you install a remote controller to one of a switch box and the surface of a wall, secure
the space shown in following figure. If spaces run short, it will become difficult to remove a remote
controller.
Secure enough space where a flat-blade screwdriver to take off a case can be inserted.
¢ Installation
• Connection pattern
NOTE: Connection pattern is different according to type of Indoor unit.
Floor/Ceiling type
All wall mounted type
• Pattern A
1. Connect the end of remote controller cable directly to the exclusive terminal block.
2. Set the DIP switch (SW1) to "2WIRE" on the PCB of the indoor unit.
NOTES:
• Layout of terminal block and PCB is varies depending on the type of indoor unit.
• Operation may fail if it is connected to the outdoor unit or the terminal block for power
supply.
2-6. Wired remote controller (Touch panel: UTY-RNRUZ)
Indoor unit type
All cassette type
All duct type
All floor type
All ceiling type
Functional earthing
(If necessary)
Remote controller cable
(Non-polar)
2 (30) or more
2 (30)
or more
9 (220)
or more
Terminal block
Indoor unit PCB
Set the DIP switch
(SW1) to "2WIRE"
- (05-59) -
Unit: in (mm)
2 (30)
or more
Connection pattern
Pattern A
Pattern B
2. Control units