Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 710

4. When the "Close" on the message screen is touched, the display returns to the R.C. Address
Setting screen. Turn on the power again.
NOTES:
• Perform manual address setting only when setting the address with an arbitrary number. Indoor
unit remote controller address setting is necessary. Set the remote controller address of indoor
units connected by the same remote controller cable within a range of 1 to 9 and A (10) to F
(15) so that there is no duplication. (Do not set to "0".)
• The address of this unit is set within a range of 1 to 32, but set it so that it does not duplicate the
remote controller address of an indoor unit connected by the same remote controller cable.
¢ Resetting the manual address setting number
1. Touch "Address Reset" on the R.C. Address Setting screen.
2. A verification screen is displayed. When the "Yes" is touched, a message screen is displayed.
3. When the "Close" on the message screen is touched, the display returns to the R.C. Address
Setting screen. Turn on the power again.
2-15. Wired remote controller (Touch panel)
Manual Addressing
Setting is reflected after the power is
turned on again.
Close
R.C.Address Setting
Current Address [001–05]
Manual Addressing
Address Reset
Back
R.C.Address Setting
The address will be returned to factory
setting. OK?
No Yes
Manual Addressing
Setting is reflected after the power is
turned on again.
Close
- (07-110) -
2. Function settings