Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 661

¢ Function setting method
1. After verifying that the system is operating normally, press the MODE/EXIT button (SW107)
once.
LED105
2. Press the SELECT button (SW108) to display "F3" on LED104.
1
* : Do not set "F1" and "F9" usually since they are used for maintenance.
Monitoring mode
LED105
3. When "F2" is displayed on the LED104, press the ENTER button (SE109). Indicator on the
LED105 flashes, and the flashing of "F2" on the LED104 stops and lights a number.
LED105
4. With referring to
code number of the mode you want to set on the LED105.
LED105
Then, press the ENTER button (SW109) to confirm the mode you want to set.
Flashing of LED105 stops and lights a number, and the lit number on the LED104 starts to
flash.
LED105
5. Again, with referring to
display the code number of the function you want to set on the LED104.
LED105
Then, press the ENTER button (SW109) to confirm the function you want to set.
Flashing of LED104 stops and lights a number.
LED105
To set another function, press the ENTER button (SW109) in the completed state of current
setting. Then, repeat steps 4. and 5. to set each function.
LED105
2-1. Setting on outdoor unit PCB
LED104 LED105
Setting mode
LED104 LED105
1
*
(The display of the LED104 changes each time the SELECT button is pressed.)
LED104
LED105
"Setting list" on page 07-63, press the SELECT button (SW108) to display the
Example: To select switching between Forced stop and Emergency stop
LED104
LED105
LED104 LED105
"Setting list" on page 07-63, press the SELECT button (SW108), and
Example: To select the Emergency stop function
LED104 LED105
LED105
LED104
LED105
LED104
LED104
Function mode
LED104 LED105
LED104
LED104
LED104
LED104
LED104
LED104
- (07-61) -
Error history mode
LED104 LED105 LED104
1
*
2. Function settings