Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 671

¢ DIP switch setting
• SET2-2: "Edge" or "Pulse" selection of external input
SET2-2
Off
On
• SET2-3: Switching of Fan delay function
Fan delay is a function to delay the stop of cooling fan when the air conditioner is stopped.
When auxiliary heater is connected, this switch should be set at "On (Enabled)". When connecting
the auxiliary heater, be careful enough.
SET2-3
Off
On
NOTE: When SET2-3 is set to "Off (Disabled)", use room temperature sensor of wired remote con-
troller to prevent erroneous detection of room temperature.
• SET2-4: Setting prohibited
SET2-4
Off
On
• SET3-1, 3-2: Custom code switching of wireless remote controller
This DIP switch sets the custom code of the wireless remote controller of an indoor unit.
If multiple indoor units are being installed in the same room, switch the custom codes of the corre-
sponding wireless remote controllers in order to prevent their signals from being mixed.
When switching the custom code of the wireless remote controller of an indoor unit, be sure to al-
so switch the code setting on the paired wireless remote controller at the same time.
SET3-1
Off
On
Off
On
How to switch the code on the wireless remote controller:
2-2. Setting on indoor unit PCB
External input select
Edge
Pulse
Fan delay
Disabled
Enabled
Fan delay
Off (Fixed)
Setting prohibited
SET3-2
Off
Off
On
On
1. Press the MODE button for more than 5 seconds to start the
code change.
2. Press the SET TEMP.
code.
3. Press the MODE button again to complete the code change.
- (07-71) -
Factory setting
Factory setting
Factory setting
Custom code
Type A
Type B
Type C
Type D
or button to select the desired
A B C D
♦
♦
♦
Factory setting
♦
2. Function settings