Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 695

7. Touch "Yes" on the verification screen.
• When the setting is properly set up on the indoor unit, the set number will be displayed in
Setting No. (GOOD)
• When the setting is not set up correctly, "-" is displayed in Setting No. (ERROR) Back to the
previous step and perform the setting again.
RELATED LINKS
"Completion of setting mode"
"Function details" on page 07-96
¢ Setting up each indoor unit
Setting must be performed on each indoor unit by repeating following procedures.
• "Preparation" on page 07-93
• "Indoor unit function setting"
Indoor unit
01
¢ Resetting the power after setting up all indoor units
NOTES:
• If the reset is not performed, function cannot be read correctly.
• After all the functions have been set, the circuit breaker needs to be switched off for at least 2
minutes.
– After the 2 minutes has passed, power can be restored.
– The set function is stored in the PCB and will remain in memory even when the power of in-
door unit is turned off.
However setting function is effective after disconnecting the power supply and then recon-
necting it.
• Record the latest configuration of the indoor unit function setting on a label, and put the label on
the unit so it can be used for after-sales service operations.
2-8. Indoor unit (setting by UTY-RNRUZ)
Function Settung
Function setting will be performed. OK?
No Yes
GOOD
Function Setting
Address [002–01]
Function No. [30]
Setting No. [01]
Back Setting
on page 07-47
on page 07-93
Indoor unit Indoor unit
00 0 01 01 0 01 02 0
Wired remote
controller
(Touch panel)
ERROR
Function Setting
Address
Function No.
Setting No.
Back
Indoor unit Indoor unit
01 13 0 01
Wired remote Wired remote
controller controller
(Touch panel) (Touch panel)
- (07-95) -
[002–01]
[30]
[ – ]
Setting
Indoor unit
14 0 01 15 0
2. Function settings