Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 641

6. Confirm the selected indoor unit address data by pressing the START/STOP
data will be transferred to the indoor unit.
• When the address data is properly set up on the indoor unit, the set number will be dis-
played. (GOOD)
• When the address data is not set up correctly, "- -" is displayed. (ERROR) Back to the previ-
ous step and set up the indoor unit address data again.
 Refrigerant circuit address setting
NOTE: Perform this setting on the master remote controller.
1. In initial display of the address setting mode, by pressing SET TEMP. "
TEMP. " " button, select a remote controller address. (Select the indoor unit you want to oper-
ate.)
If the indoor unit you want to operate has already been selected, skip this step.
Initial display of
address setting mode
2. Press the FAN button. "Function number" indicator flashes.
3. Display the function number "02" by pressing SET TEMP. "
ton.
1-4. Address setting by remote controller
ERROR
Example: When remote controller address
"01" is selected
Function number
" button or SET TEMP. "
Function number
- (07-41) -
button. The
/
GOOD
" button or SET
Remote controller address
1. System settings
" but-