Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 683

¢ Setting up each indoor unit
Setting must be performed on each indoor unit by repeating following procedures.
• "Preparation" on page 07-78
• "Indoor unit function setting"
• "Confirmation of function setting"
• "Completion of function setting mode"
• "Reconfirmation of function setting"
When the custom code is different to " " (factory setting), only following procedures need to be per-
formed.
• "Preparation" on page 07-78
• "Completion of function setting mode"
• "Reconfirmation of function setting"
¢ Resetting the power after setting up all indoor units
Important:
• If the reset is not performed, function cannot be read correctly.
• After all the functions have been set, the circuit breaker needs to be switched off for at least 2
minutes.
– After the 2 minutes has passed, power can be restored.
– The set function is stored in the PCB and will remain in memory even when the power of in-
door unit is turned off.
However setting function is effective after disconnecting the power supply and then recon-
necting it.
• Record the latest configuration of the indoor unit function setting on a label, and put the label on
the unit so it can be used for after-sales service operations.
Number "0" setting will not be indicated on TIMER lamp and FILTER lamp.
Once the RESET button is pressed on the remote controller, the operation mode will be set to the
AUTO MODE.
Adjust the operation mode to either cooling or heating before starting the operation of the air condi-
tioner.
NOTE: If custom code other than " " is set, the remote control must be set accordingly to the in-
door unit setting.
2-4. Indoor unit (setting by wireless remote controller)
on page 07-78
on page 07-80
on page 07-81
on page 07-81
01-01 01-02
on page 07-81
on page 07-81
- (07-83) -
01-03
2. Function settings