Fujitsu AIRSTAGE J-IIIL Design & Technical Manual page 681

¢ Completion of function setting mode
• The position of the MANUAL AUTO button varies depending on the model. For the actual position
of the button on each unit, refer to the operation manual.
• If the MANUAL AUTO button is pressed continuously for 10 seconds or more, the error will be dis-
played. In this case, release the button or turn off the power.
1. Press and hold the MANUAL AUTO button for 3 seconds. The brightness of each LED lamp is
darkening though the content of the display does not change.
2. Press the RESET button.
For the custom code setting of b, c, or d, perform the setting after pressing the RESET button.
• After completing the procedure above, no function setting signal is received. If the function
setting signal is sent, 5 short beeps will be emitted indicating an error.
• When returning the function setting mode again, press the MANUAL AUTO button for 3 sec-
onds.
¢ Reconfirmation of function setting
1. While holding down the FAN and the SET TEMP.
function setting mode will be activated.
2-4. Indoor unit (setting by wireless remote controller)
MANUAL AUTO
IR receiver unit
FAN
SET TEMP. ( )
RESET
- (07-81) -
3 short beeps
MANUAL
AUTO
RESE T
buttons, press the RESET button. The
Function setting
mode display
2. Function settings